Not yet covered here is you must go into GSBManager and setup GSB for the indicator settings 2 pass method.

This is covered in the 2 pass indicator method in the methodology.

The result of this is a optsettings file is saved. Lets say CL15.30.test. This will be referred to later.



Leave path mode and path on defaults, unless your GSB is not in c:\gsb\


Settings group.

Click here to enter in the settings


Click add

then click here



Load the file saved in GSB at the top of this section.



Click command sequence



Click add & build


Here are all the commands currently possible.

We will show them all, but not all must be used.